pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more the following
measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
Note:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, the distance must be at
least 20 cm between the radiator and your body, and fully supported by the operating
and installation configurations of the trans and its antenna(s).
Thank you for purchasing this Emerson Strong Bass Portable Bluetooth Speaker ER-
X300. If you encounter any problems with the set up or operation of this item, please call the
Emerson Consumer Products Corp., Customer Service Hotline, toll free, at
1-800-898-9020
.
Unpacking and Setup
•
Remove the unit from the box and remove all packing material from the unit.
Save the packing
material, if possible, in case the unit ever needs to be serviced or transported. The original
box and packing material is the only safe way to pack your unit to protect it from damage in
transit.
•
Remove any descriptive labels or stickers on the front or top of the cabinet. Do not remove any
labels or stickers from the back or bottom of the cabinet.
•
The serial number on the bottom of your unit and write this number in the space provided on the
Warranty page of this manual.
•
Place your unit on a level surface such as a table, desk or shelf, out of direct sunlight, and away
from sources of excess heat, dirt, dust, moisture, humidity, or vibration.
Protect Your Furniture
This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you
operation the controls. These ‘feet’ are made from non-migrating rubber material specially formulated
to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may causes the rubber ‘feet’ to soften, and leave
marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware stores and home
improvement centers everywhere, and apply these pads to the bottom of the rubber ‘feet’ before you
place the product on fine wooden furniture.
Power Source
This product is designed to be powered by a built-in rechargeable lithium-ion battery and a
DC5V/2.4A USB Adapter via a USB cable provided.
Preparation for Use
