1592010400 PROG TOOL EN 19.03.2020 PROG TOOL
5/8
4.3 PROGRAMMING FROM HOT-KEY TO HOT-KEY
This function allows to copy any HOT KEY that is already programmed.
Connect the power supply to the terminal blocks 13 and 14
and make sure the “Power”
Led is turned on.
1.
Insert the original key in the connector on the top side of the programmer.
2.
Insert the key to be programmed in the “Hot-Key Copy” connector placed on the PROG
TOOL front
3.
Press the “Copy” button to start the key copying procedure. During the operation the “Copy”
Led is blinking green
4.
After a few seconds the “Copy” Led stops blinking and provides the result of the operation
RED “Copy” Led =
error during the HOT KEY programming, repeat the operation and
eventually replace the key.
GREEN “Copy” Led =
successfully performed operation; Hot Key has been correctly
programmed.
5.
Remove the new key. It is possible to create further copies by inserting a new Hot Key to be
programmed.
Programmed Hot Key to be
copied
Interface Led
Press to start copying
Insert
the
key
to
be
programmed
Power Supply
Summary of Contents for dixell
Page 1: ...PROG TOOL ...
