11. Carefully lift the fan and seat the hanger ball in
the hanger bracket (Figure 9). Be sure the groove
in the hanger ball is lined up with the tab on the
hanger bracket (Figure 8).
12. Swing the retaining strap closed (as shown in
Figure 10) on the hanger bracket and reinstall the
socket head cap screw. Securely tighten the
socket head cap screw.
13. REFER TO YOUR CEILING FAN OWNER’S
MANUAL AND COMPLETE THE WIRING
INSTRUCTIONS.
HANGER BRACKET
RETAINING
STRAP
OUTLET BOX
HANGER BALL
NOTE: SUPPLY WIRES AND
FAN WIRE OMITTED FOR
CLARITY
Figure 9
HANGER BRACKET
OUTLET BOX
"A"
"B"
"A"
"B"
RETAINING
CLIP
SOCKET HEAD CAP SCREW
Figure 10
8. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 7).
6
10. Remove the socket head cap screw with the hex
wrench (supplied) securing the retaining strap to
the hanger bracket (Figure 8); retain the socket
head cap screw for later use. Swing open the
retaining strap as shown in Figure 8.
SETSCREW
PIN
HANGER
BALL
CEILING
COVER
DOWNROD
Figure 7
HEX WRENCH
(SUPPLIED)
TAB
SOCKET HEAD
CAP SCREW
RETAINING
STRAP
HANGER
BRACKET
Figure 8
9. Install the hanger ball (only use the hanger ball
supplied with this kit) on the downrod as follows.
Route the motor leads through the hanger ball and
slide the hanger ball over the downrod (Figure 7).
Install the pin through the holes at the top of the
downrod and slide the hanger ball up the downrod,
aligning the ball so the pin is captured in the groove
in the top of the hanger ball. Pull the hanger ball up
tight against the pin and securely tighten the
setscrew in the hanger ball. A loose setscrew could
create fan wobble.
Only use the hanger ball and mounting bracket
supplied with this kit. Any other combination of
hanger ball and mounting bracket could result
in fan becoming loose and falling.
Failure to seat tab in groove could cause
damage to electrical wire and possible shock or
fire hazard.
It is critical that the pin in the hanger ball is
properly installed and the setscrew securely
tightened. Failure to verify that the pin and
setscrew are properly installed could result in
the fan falling.
WARNING
!
WARNING
!
WARNING
!
