NOTE: Take care not to scratch fan housing when
installing blades.
9.
Turn the fan assembly upside down in preparation
for mounting the fan blade assemblies.
NOTE: Remove and discard the four shipping
spacers and screws from the motor hub.
10.
Rotate the motor hub until the flange screw hole
is next to the cutout in the switch housing plate.
Loosely attach one blade assembly to the motor
hub using two M6 x 14 flange screws preassem-
bled in flange. Make sure the screws are NOT
tightened. (Figure 6.) Repeat this procedure for
the other four blade assemblies.
11.
The blade flanges have an interlocking feature
that must be fully engaged before tightening the
screws. Make sure all the flanges are properly
engaged and then tighten the flange screws in a
clockwise sequence. If one of the flanges does
not seat properly on the motor hub, loosen the
adjacent flange screws, re-engage and reseat the
flanges, then tighten the screws again.
12.
Engage the connector of the switch housing
assembly with the motor connector (Figure 7).
The two connectors are keyed and color-coded
and must be mated correctly (color-to-color)
before they can be engaged. Make sure the con-
nector latch closes properly.
13.
Remove the three switch housing mounting
screws (Figure 7) from the switch housing plate.
Position the switch housing assembly on the
switch housing plate and align the holes in the
switch housing assembly with the holes in the
plate. Secure the switch housing assembly by
installing the three mounting screws (Figure 8).
NOTE: Do not pinch wires between the switch
housing assembly and the switch housing plate.
14.
You have now completed the assembly of your
new ceiling fan. You can now proceed with hang-
ing and wiring your fan.
5
FAN BLADE
BLADE FLANGE
M5 x 6 WASHER HEAD SCREWS (3)
BLADE WASHERS (3)
Figure 5
BLADE
FLANGE
SWITCH
HOUSING
PLATE
PREASSEMBLED M6 x 14
FLANGE SCREW (2)
MOTOR HUB
Figure 6
SWITCH HOUSING
MOUNTING SCREW (3)
SWITCH HOUSING
ASSEMBLY
Figure 8
SWITCH HOUSING
MOUNTING SCREW (3)
SWITCH HOUSING
CONNECTOR
MOTOR
CONNECTOR
SWITCH HOUSING
ASSEMBLY
Figure 7
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
U.L. Model No.: CF935
