5
emersonfans.com
Please contact 1-800-654-3545 for further assistance
E.T.L. Model No.: CF776
GROMMET
DOWNROD
COUPLING
COVER
CEILING
COVER
Figure 3
CEILING
COVER
DOWNROD
HANGER
BALL
PIN
Figure 4
BLADE FLANGE
FAN BLADE
#10-32 x .25" SLOTTED
PHILLIPS WASHER HEAD
BLADE SCREW (3)
Figure 5
BLADE
FLANGE
SWITCH HOUSING
PLATE
REMOVE SHIPPING
RETAINER AND
SCREW (5)
1/4-20 x .5" ROUND HEAD
FLANGE SCREWS (2 PER
FLANGE/BLADE ASSEMBLY)
Figure 6
4.
Make sure the grommet is properly installed in the
coupler cover, then slide the coupler cover on the
downrod until it rests on the motor housing. Place
the ceiling cover over the downrod. Be sure that the
ceiling cover and the coupler cover are both oriented
correctly (Figure 3).
5.
Reinstall the hanger ball (Figure 4) on the downrod
as follows. Route the three 80” motor leads through
the hanger ball. Position the pin through the two
holes in the downrod and align the hanger ball so the
pin is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball. A
loose setscrew could create fan wobble.
6.
The fan comes with blue, black and white leads that
are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end of
leads.
7.
Mount blade flange to fan blade using three
#10-32 x .25” slotted Phillips washers head screws
(Figure 5).
8.
Repeat this procedure for the remaining four blades
and flanges.
9.
Turn the fan assembly upside down in preparation
for mounting the fan blade assemblies.
NOTE: Take care not to scratch fan housing when
installing blades.
10.
Carefully unscrew each shipping retainers from the
motor housing. Discard the five screws and
shipping retainers (Figure 6).
11.
Attach the flange/blade assembly to the motor hub
using the two 1/4-20 x .5” round head flange
screws (supplied). Make sure the screws are
tightened securely (Figure 6).
12.
Repeat this procedure for the other four blade
assemblies.
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
WARNING
!
