4
4. Reinstall the hanger ball (Figure 4) on
the downrod as follows. Route the
three 80” motor leads through the
hanger ball. Position the pin through
the two holes in the downrod and align
the hanger ball so the pin is captured in
the groove in the top of the hanger ball.
Pull the hanger ball up tight against the
pin and securely tighten the setscrew in
the hanger ball. A loose setscrew could
create fan wobble.
5. The fan comes with blue, black and
white leads that are 80” long. Before
installing fan, measure up
approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut
off excess leads and strip back
insulation 1/2-inch from end of leads.
6. Engage the connector of the switch
housing assembly with the motor
connector (Figure 5). The two
connectors are keyed and color-coded
and must be mated correctly (color-to-
color) before they can be engaged.
Make sure the connector latch closes
properly.
7. Remove the three switch housing
mounting screws (Figure 5) from the
switch housing plate. Position the
switch housing assembly on the switch
housing plate and align the holes in the
switch housing assembly with the holes
in the plate. Secure the switch housing
assembly by installing the three screws
(Figure 6).
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
To avoid possible fire or shock, do not
pinch wires between the switch cup
assembly and the switch cup plate.
WARNING
!
DOWNROD
PIN
HANGER BALL
CEILING
COVER
SETSCREW
Figure 4
8. Turn fan assembly upside down in
preparation for mounting fan blade
assemblies.
9. Mount blade flanges to fan blades
using three 3/16-24 x 1/2” slotted
Phillips blade screws and three blade
washers (Figure 7).
NOTE: Take care not to scratch fan
housing when installing blades.
NOTE: Remove and discard the four
shipping spacers and screws from the
motor hub.
MOTOR CONNECTOR
SWITCH HOUSING
CONNECTOR
SWITCH HOUSING
MOUNTING SCREW (3)
Figure 5
SWITCH
HOUSING
ASSEMBLY
MOUNTING
SCREWS (3)
Figure 6
FAN BLADE
BLADE WASHER (3)
3/16-24 x 1/2" SLOTTED
PHILLIPS BLADE SCREW (3)
BLADE FLANGE
Figure 7
BP7287 60" DESIGNER FAN 3/10/05 10:42 AM Page 4
