23
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF370
HOT
BLACK
FAN/LIGHT
WALL
CONTROL
TRAVELER
WIRE
BLK
BLK
LOAD
BLACK
GROUND
NEUTRAL
RECEIVER LOCATED
WITHIN THE CEILING
COVER
SECOND
WALL
CONTROL
PURCHASED
SEPARATELY
OFF
ON
....
OFF
ON
....
3-WAY INSTALLATION
(One Fan controlled by two different Wall Controls)
(See Figures 35 and 36.)
8.9
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Outlet Box.
8.10
At all Wall Box locations remove Faceplates and
Screws from Existing Controls. Pull Controls out
from Wall Boxes and determine which Wall Box
contains the “HOT” Wire and which Wall Box
contains the “LOAD” Wire. Also, identify Traveler
Wires which are common to both Wall Boxes.
Disconnect Wires from Existing Controls only.
Do not attempt to disconnect any Wires not already
connected to Existing Controls.
8.11
Before installing the Wall Control, place the Wall Control
in “OFF” mode by pushing “ON/OFF” Switch to the
“OFF” position.
8.12
Install a Wall Control in the Wall Box containing the
“HOT” Wire first. Connect the Black Wire of the Wall
Control to the “HOT” Wire. Securely connect the Wires
with Wire Connector, supplied.
8.13
Connect the other Black Wire of the Wall Control to both
remaining Traveler Wires in the Wall Box and secure
with Wire Connector, supplied.
Figure 35
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
WARNING
!
8. Wall Control Installation
(Continued)
