Installation, Operation and Maintenance Manual
MAN-02-05-62-0742-EN Rev. 0
December 2019
Greasing of Thrust Gage
The quantity of grease needed is stated on the assembly drawing.
The bearing is greased on each side with half of the described quantity.
1. Firstly the inner thrust washer is mounted.
2. The Thrust gage is mounted with the greased side
downwards and the other side is greased with the
remaining grease.
3. The last thrust bearing is mounted.
Mounting of Bottom Part and Cover
1. Mount the bottom cover part, turn clockwise.
2. The bottom cover is tightened with special tools.
Tightening torque is stated on drawing.
If special tools are not available, pins fitting into
the holes are to be used.
3. When the bottom cover has been tightened, it must be positioned below the actuator housing. This is check
with a straightedge.
36
BHH Re-Mounting
Section 11: BHH Re-Mounting
