DOC00038A000 Rev. 00 02/13/20 MY6381 • Page 7 of 16
Globe & Guard Assembly or Lamp Replacement Instructions (Continued)
5.
Hand pressure along may not provide enough torque to unseat the handlamp's handle. If necessary, use a 3/4" socket wrench,
as shown below, to provide additional leverage to unseat the handle. Do NOT use a hammer or other striking tool to apply impact
force to the Wrench Tool as this may cause damage to the handle of the handlamp.
FIGURE 8: USING A 3/4" SOCKET WRENCH TO UNSEAT THE HANDLE
6.
Once the handle is unseated from the Guard & Globe Assembly, install a new Guard & Globe Assembly and lamp. The Guard
& Globe Assembly plus the installation tools are provided in the
EHLEDTKG
replacement kit. A new lamp is available in the
EHLEDTKb
replacement kit. Installation tools to complete this project are also included in this kit. Install the replacement lamp into
the socket on the handle.
FIGURE 9: HANDLAMP WITH REPLACEMENT LAMP INSTALLED
7.
Thoroughly clean the Guard & Globe Assembly, external threads and top mating surface of the handle with a clean cloth. Make sure
liquid DOES NOT enter the handle.
