Chapter 1
ATCA-F140 Installation and Use (6806800M67H)
17
Introduction
1.1
Features
The ATCA-F140 is a hub board as defined
in PICMG 3.0 Revision 3.0 Advanced TCA Base
Specification
and
PICMG 3.1 Revision 1.0 Specification Ethernet/Fiber Channel for AdvancedTCA
Systems
. It supports several Base and Fabric Channel Ethernet interfaces to the Zone 2
backplane. It also supports 1Gb, 10Gb, and 40Gb Ethernet uplinks to the front panel and to a
Rear Transition Module (RTM) through the Zone 3 connector.
Broadcom Ethernet switches and PHYs are used for the base and fabric channels. The entire
board is managed by a Freescale P2020 QorIQ Integrated Processor.
The ATCA-F140 provides one AMC bay. This bay is designed to support a processor AMC
module for additional applications processing capabilities on the board.
See the list below for the key features of the ATCA-F140:
Single slot ATCA form factor (280 mm x 322 mm)
Freescale P2020 QorIQ Integrated Processor for the on board service processor functions
Two DDR3 memory DIMM slots; each of which can support up to 2 GB of DDR3 SDRAM
with ECC for a total memory capacity of 4 GB
Two redundant banks of 32 MB Boot Flash memory
2 GB embedded USB Flash module for User Flash memory
Onboard SATA connector for a 2.5" SATA drive with selectable interface to either the
service processor or the processor AMC
Real time clock
RJ-45 UART Console interface to service processor on front panel
RJ-45 10/100/1000 BaseTx Ethernet Management port on the front panel for P2020 QorIQ
Integrated Processor
Broadcom BCM56334 managed switch device for the Base Channel (24 1G-SGMII and four
10G-XAUI ports)
Two Fabric Channel 40G (QSFP+) uplink ports on the front panel
Multiple 1 GbE SGMII and 10 GbE XAUI ports routed to Zone 3 connectors for base and
fabric uplink channels on RTM
Two 40G ports routed to Zone 3 connectors for fabric uplink on RTM
StockCheck.com
