- 7 -
Note:
Needle threader can help the thread pass through the needle eye. First get the ring of needle threader goes
across the needle eye from back to front, then put the thread into the ring. Draw back the needle threader and
the thread will be pulled through the needle eye. (Fig.7 & Fig.8)
Fig.7
Fig.8
2.
Replacing the bottom bobbin
1)
Slide the release button besides the bobbin cover to the right and remove the bobbin cover (Fig.9).
2)
Put the new bobbin in the holder. Leave 10cm of thread hanging out (Fig.10 & Fig.11).
3)
Lift up the presser foot lifter. Hold the end of the upper thread with one hand, and turn the hand wheel
counterclockwise a round with the other hand to make the needle go down and up, the needle thread will
pick up the bobbin thread and pull it up through the hole under the needle (Fig.12 & Fig.13).
4)
Replace the bobbin cover. Separate the two threads and pull them to the back of the machine under the
presser foot, leaving about 15cm hanging there. (Fig. 14)
Caution:
Always switch off the appliance and disconnect it from the power supply when replacing the bottom
bobbin.
Please use metal bobbins, otherwise the magnetic holder cannot tense the bobbin thread and work
rightly.
Fig.9
Fig.10
Fig.11
Summary of Contents for SEW-121816
Page 1: ......
