- 6 -
2.
Change to the comb attachment 9mm or 12mm and cut at the back of the head.
3.
Change to one of the shorter combs 3mm or 6mm to trim sideburns. Then change to longer comb 9mm or
12mm, and continue to cut at the top of the head.
4.
Use attachment comb 9mm or 12mm to cut at the top of head from back to front against the direction in
which the hair normally grows. Attachment comb 3mm or 6mm are used to achieve a close crew cut.
For longer hair on top, use the comb provided and lift the hair on the top of the head. With the hair lifted, cut
the hair to the desired length.
5.
Finally, use the clipper without an attachment comb for close trimming around the ears and back of neck.
The four basic areas and their corresponding comb attachments illustrated below are for your reference.
CLEANING AND MAINTANENCE
1.
Ensure that the hair clipper is disconnected from the mains supply before cleaning.
2.
Never immerse the hair clipper in water or any other liquids. Never rinse the appliance either. Always ensure
that the plug is kept dry.
3.
Use the provided brush to take off hair from the clipper.
4.
Clean the outside of the appliance with a slightly wet cloth. Dry it up before use.
5.
Oil and Alignment
：
You clipper was carefully examined to ensure the blades were oiled and aligned before leaving the factory.
Blades must be realigned if they have been removed for cleaning or replacement.
