emerio HK-122941, Instruction Manual

Page: 6 / 39

- 5 -
PARTS DESCRIPTION
1. Station blades
2. Moving blades
3. Hanging loop
4. Power cord
5. ON/OFF switch
6. Blade lever
7. Attachment comb (3/6/9/12 mm)
8. Scissor
9. Comb
10. Oil
11. Brush
BEFORE USE
1.
Make sure that your clipper is clean, properly oiled and in perfect working condition.
2. Seat the person so their head is approximately at your eye level. This allows ease of visibility while cutting and
a relaxed control of the unit.
3. Place a towel around the neck and shoulders of the person having the haircut.
4. Before cutting always first comb the hair so it is tangle free.
5. Never use the product to cut wet hair. It is designed to work in dry condition only.
USE
1.
Hold the desired attachment comb with teeth up and snap the attachment comb onto the clipper blades.
Make sure the attachment comb is firmly attached. The attachment combs have 4 sizes (marked on the
combs):

Attachment Comb #1 leaves about 3mm (1/8 inch) hair length.

Attachment Comb #2 leaves about 6mm (1/4 inch) hair length.

Attachment Comb #3 leaves about 9mm (3/8 inch) hair length.

Attachment Comb #4 leaves about 12mm (1/2 inch) hair length.
2. Plug in the appliance, then slide the ON/OFF switch to turn on the appliance.
3. Hair must be clean, dry and combed. You have to start from the highest length of hair, and then reduce
gradually to prevent cutting more hair than requested.
4. Hold the clipper lightly against the head with the comb teeth pointing upward. Gradually and slowly lift the
clipper through the hair, trimming just a little at one time and often comb hair in order to obtain the
requested hair style.
5. The lever is conveniently located near your thumb (if you’re right-handed) so it can be adjusted easily while
the clipper is in your hand. The lever adds versatility to your clipper by allowing you to gradually change the
closeness of your cut without an attachment comb.
When the lever is in the uppermost position, the blades will give you the closest cut (1).
Pushing the lever downward gradually increases the length of hair left.
In addition, if heavy hair jammed the blades, it will help remove hair by turning the lever.
6.
After using, slide the ON/OFF switch to turn off the appliance. Unplug the power cord.
CUT EXAMPLE
1.
Attach comb attachment 3mm or 6mm.
Starting from the center bottom of the back head, gradually lift the clipper upwards and outwards through the
hair, trimming just a little at one time.
HK-122941 EN