24
25
How to Use
Installation method 1
Initial operation
To Select Filtered Water
(Fig.14)
How to shut off the water flow from
your ionizer
1
2
1
2
3
IMPORTANT! Complete all steps of installation method 1.(P 19) Make sure the main power switch is in the
OFF position on the back of the unit, and the unit is plugged into an electrical outlet.
Turn the power button to the "ON" position on the back of the
ionizer. (Fig.11)
- The power button is ALWAYS left on.
Press the MODE button once. (Front panel of ionizer) (Fig.12)
TURN ON THE WATER
Turn on the water by opening the water supply valve under the sink.
Turn flow control knob on front of ionizer to ON position.
These will always remain in the ON or OPEN position.(Fig.13)
Fig.11
Fig.12
Fig.13
Fig.14
START WATER FLOW THROUGH YOUR IONIZER
- Turn on the "Lever" on the side of your faucet to
start the water flow.
With the water running through your faucet, press
the "FILTERED" button.
The display panel will show a green symbol.
The Filtered water will come out of the top spout.
NOTE
The water may initally come out discolored(light to charcoal grey)
due to carbon particulate in the new filter. This is not harmful and
is typical of all carbon filters. Allow the water to flow for 2-3 minutes
in the "Filtered" mode and this will flush all the carbon dust.
Faucet Control Lever
Filtered Water
With the water running through your faucet, turn the lever to the
OFF position.
The water will stop and the display panel will go dark indicating
the ionizer is in standby mode.
NOTE
Your ionizer will always "remember" the last setting used.
If the previous selection was Alkaline level 2, when you start
flow through the ionizer next time you use the ionizer it will
automatically process at Alkaline level 2.
To select Alkaine Water
(Fig.15)
To select Acidic Water
(Fig.16)
1
2
1
2
START WATER FLOW THROUGH YOUR IONIZER
Depress the "ALKALINE" button to select the desired setting
from 1~4.
The Alkaline Water will come out from the top spout.
The display panel on the front of the faucet will show a blue
Alkaline indicator and a number corresponding to the level
selected.
TO CHANGE LEVELS OF ALKALINE WATER
To select a different level, depress the "ALKALILNE" button to
move to next level until the desired setting level is achieved.
The number will change accordingly.
START WATER FLOW THROUGH YOUR IONIZER.
Depress the "ACIDIC" button to select the desired from 1~4.
The Acidic Water will come out from the top spout.
The display panel on the front of the faucet will show a red
Acidic indicator and a number corresponding to the level selected.
TO CHANGE LEVELS OF ACIDIC WATER
To select a different level, depress the "ACIDIC" button to move
to next level until the desired setting level is achieved.
The number will change accordingly
NOTE : Acidic Water is for external use only. DO NOT DRINK.
Faucet Control Lever
Fig.15
Alkaline Water
Acidic Water
Faucet Control Lever
Fig.16
Alkaline Water
Acidic Water
