3
3-32
EMC Disk-Array Processor Enclosure (DPE) Deskside Model FC4400/4500 Hardware Reference
Servicing and Upgrading a Deskside DPE
Figure 3-21
Removing the Memory Module from the SP
After removing the memory module, if you want to ship the SP, store it in its
antistatic bag and special shipping package. Then remove and store the ESD
wristband.
Installing an SP
Memory Module
Depending on the memory size (in megabytes), the SP memory
module can contain chips on only one side or on both sides.
1. Place the SP and the memory module (DIMM) on a static-free
work surface.
2. On the SP, install the DIMM in the appropriate connector as
shown next.
A memory module has a notch on its edge near pin
1 so that you can insert it
only one way. Install memory modules one at a time and in order starting
with connector 1 (refer to the figure below).
Alignment
notch
A. Use your thumbs to
push out on the locking
tabs, and use your
fingers to lift the DIMM
upward until it releases
from the tabs.
B. Lift the module out of
the connector, and
place it in its own
antistatic packaging.
Locking tabs
Locking tabs
