3
3-14
EMC Disk-Array Processor Enclosure (DPE) Deskside Model FC4400/4500 Hardware Reference
Servicing and Upgrading a Deskside DPE
Figure 3-4
Removing a Disk Filler Module
Figure 3-5
Removing a Disk Module
After removing a disk module, wait for the activity lights on the other disk
modules to resume a steady flicker before removing another disk module.
The activity lights show that the licensed internal code (LIC) has
rediscovered the FC loop.
Continue to the next section to install the new or replacement disk
module.
A.
Grasp the disk module filler handle
so that your thumb is on the latch.
Latch
B.
Push the latch, and slowly pull the
module from its slot.
A.
Grasp the disk module handle
so that your thumb is on the latch.
Latch
B.
If the active light is on steadily, push
the latch, and slowly pull the module abou
3 cm (1 inch) from its slot. Wait 30
seconds for the disk to stop spinning.
Then remove the module.
If the active light is off or mostly off,
you do not need to wait for the disk to stop
spinning. Push the latch, and slowly pull th
module from its slot.
