32
Install - Step 7
Power up and cable optional DAEs
This step describes how to add DAE hardware to a newly initialized CX4-120 storage
system. It assumes you have already installed your rails and enclosure hardware in a
cabinet or rack, and have just completed setting up an SPE, SPS, and the DAE-OS
according to the instructions in steps 1 and 2 of this guide. To complete the
installation of optional DAEs, you must:
•
Connect the DAEs to active AC power
•
Assign a unique enclosure address to each DAE
•
Connect the DAEs to the system back-end bus
If your system was installed in a cabinet or rack prior to shipment, skip this step and go
directly to page 41.
Connecting AC power
The DAEs will power up immediately once you attach them to an active AC power source.
1. Plug an AC power cord into each DAE power/cooling module, as shown below.
Make certain you secure the power cord with the retention bails (strain reliefs) at each
connector. The strain reliefs prevent the power cord from pulling out of the connections.