EMC-PARTNER ESD3000, User Manual, Page: 29 / 66

ESD3000-System
29/66
6.4 The different software menus of the ESD3000
6.4.1 Repetition, number of pulses, count mode
Number of pulses
charging voltage selected voltage level
voltage level selected L2 = 4 kV
When the „down button „ has been pressed twice - the display looks like:
charging voltage
selected voltage level
voltage level selected L2 = 4 kV
The number of discharges can be
selected after the ENTER button
has been pressed
When the „ENTER „ button has been pressed the displays turns to:
charging voltage
selected voltage level
voltage level selected L2 = 4 kV
With the „UP“ and „DOWN“ button
the number of discharges can be
modified.
Remark: up to 1000 discharges steps are 1, over 1000 steps change to 1000. Holding the „UP“ or „DOWN“
button pressed, the steps changes from 1 to 10 or from slow to fast.
The „ENTER „ button must be pressed to quit the selected pulse number:
charging voltage
selected voltage level
voltage level selected L2 = 4 kV
Selected number of discharges.
Repetition of the discharge pulses can be changed on same way as the pulse number. The repetition can
only for AUTO mode be selected. The repetition time can be selected from 0.05 (20 Hz) up to 30 seconds
EMCP recommends to use the air discharge mode for week points exploration. The 20Hz
repetition reduce the life span of the high voltage relay. See chapter 6.5.1.2.
Count mode
After pressing „down „ with the „ENTER“ button the count mode can be selected
charging voltage
selected voltage level
voltage level selected L2 = 4 kV
Selected count mode.
Remark: two count mode can be differed: „Disch.“ or „ALL“. In „All“ mode all released impulses will be
counted. In „Disch.“ mode only the real discharges are counted (current sensing).