EMBRON Hatteland HT20 70 Series, User Manual

Page: 54 / 154

54
IND100129-169
All specifications are subject to change without prior notice!
PCA100297-1
Specifications - Isolated Digital Input/Output Module
1/2
This information may not, in whole or in part, be copied, photocopied,
reproduced, translated or reduced to any electronic medium or machine-
readable form without the prior written consent of Hatteland Technology
AS. The products may not be copied or duplicated in any way.
Dimensions might be shown with or without decimals and indicated as mm [inches]. Tolerance on drawings is +/- 1mm. For accurate measurements, check relevant DWG fi le.
DATASHEET
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146
4 x Isolated Input + 4 x Output, Digital IO Module
Manufacturer: Hatteland Technology AS
Product:
Isolated Digital IO module (4 x 4 x Input)
Typenumber: PCA100297-1
Last Revised: 27 Apr 2022
Revision#: 20
The Hatteland Technology DIO module provide the system with 4 isolated digital output and 4 isolated digital input. The module is
attached to the motherboard via USB interface. Application software access the DIO channels via D2XX interface provided by the chip
manufacturer, i.e. in the normal case is there no requirements for low level software development. This module will mainly be integrated,
electrical and mechanical, in the final products, such as; Series X G1/G2 Panel Computers and selected Stand-alone Computers.
Description:
Digital Output Application Circuit
• Features - Independent output channels, High side switch.
- Outputs are short circuits and overload protected.
- Thermal shutdown.
- Isolated towards chassis.
- Output status/diagnostic feedback available for each output channel.
- Outputs is rated for inductive and resistive loads.
- Outputs is rated for driving small motors.
- Classified towards IEC60945 and IEC60950.
• Maximum Ratings - Voltage: 9-36V continuously.
- Load Current: 150mA.
- Response time hardware for change of output state <20ms.
- Response time hardware for diagnostic feedback <30ms.*
- Worst case short circuit current (each channel) < 1.5A.
*Typical response time at system level: 200ms.
Above: High side switch concept
• Typical Application - Low Power control / relay control.
- Medium power buzzer.
- Indicator/signal lamps.
Digital Input Application Circuits
• Features - Independent input channels.
- Fully isolated towards chassis and channel to channel.
- Short circuit and reverse voltage protected.
- Classified towards IEC60945 and IEC60950.
• Maximum Ratings - Input voltage 8-36V.
- Response time hardware <10ms.
- Input current < 20mA.