iMX RT1052 OEM Developer’s Kit - User’s Guide
Page 8
Copyright 2018 © Embedded Artists AB
Figure 2 – iMX RT1052 Developer's Kit Bottom View
2.3
Connecting - Get Started
Begin by connecting the micro-B USB connector to position 1) in Figure 1 above. Connect the other
end of the USB cable to the PC. The pre-loaded demo application will immediately start, showing some
graphics on the LCD (on the bottom side). The demo application is described in more detail in section
3 .
Meanwhile the PC will typically install drivers automatically for the UART-to-USB bridge that creates a
Virtual COM port, if they are not already installed. If you have problems the drivers can be downloaded
from the links below:
http://www.ftdichip.com/Drivers/VCP.htm
http://www.ftdichip.com/Support/Documents/InstallGuides.htm
When the driver has been installed, a new COM port will listed under “Ports” in the Device Manager as
shown in Figure 3. Please note that the actual port number will most likely be different on your
computer.
Figure 3 – Virtual COM port shown in device manager