Tinyhawk
5
emax-usa.com
charging the indicator light is green. The indicator light will turn red when charging is
complete.
Assembly
Minimal assembly is required for proper operation of the goggles. Follow the steps
below.
1. Attach the two supplied antennas by screwing them on to the SMA
connection point.
2. Place the battery cartridge in the sleeve on the backside of the head strap.
3. Feed the power lead through the loop on the top side of the head strap and
plug in the power lead to the port on the goggles. This will power the goggles.
4. Please remove antennas and power lead when traveling/storing the goggles.
Operation
Power
Power on the goggles by plugging in the power lead from the battery cartridge.
Power off by unplugging the power lead from the battery cartridge.
Video Channel Selection
There are 2 buttons (CH and FR) that can manually select the correct channel and
frequency band. The table below shows the channel and frequency band map with
the respective frequency number. This is the recommended way to change channels
to the correct frequency on tinyhawk. The CH button will cycle through the channel
number (1-8) while the FR button will cycle through the frequency band
(A,B,E,F,R,H). The frequency band and channel number will be shown in the upper
right corner of the screen when cycling through channels.
Tip:
Make sure tinyhawk is powered on. When cycling through channels it will be
easier to spot the correct one with the video feed from tinyhawk.
Caution:
Make sure the goggles are on the correct channel that tinyhawk is on. The
current selected band and channel of tinyhawk is shown in the lower right corner of
the screen.
