Tinyhawk
11
emax-usa.com
Tinyhawk VTX Settings
Vtx Schematic and Button Diagram
VTX Channel Settings with the Button
1. Normal display
All LEDs on the VTX are normally off until the button is pressed. To check band and
channel status click the button once quickly, and LED starts to indicate frequency
band and frequency channel. First indicate the frequency band and then indicate the
frequency channel. After all 2 rounds of LED display cycles, all LED will be off.
2. Menu Entry / Exit
(1)Press the button and hold for 5s to enter the menu. After entering the menu,
BAND LED lights up.
(2)Press the button and hold for 5s again to save parameters and exit the menu.
After saving and exiting the menu, all LED goes out.
3. Band and Channel parameter change
After entering menu, short click button to switch frequency group band(b)/frequency
channel (C),and the LED of the corresponding menu is lit.
4.Enter/Exit Parameters
(1) After choosing menu, press the button and hold for 2s to enter parameter option.
And the corresponding LED flash.
Notice:
When SmartAudio function is on, if the video receiver can't display image
such as showing only snow image, that is because flight controller set the VTX
frequency to an illegal one. While battery is connected you can press vtx button to
adjust the frequency to the legal one to display an image and after wards you can set
the frequency to legal one in OSD menu.
