EMAK KJK 102H Series, Operator'S Manual, Page: 93 / 200

17
7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
1. When the ignition key is turned
to «ON», the indicator light or the
dashboard remain switched off
The safety device of the electronic
circuit board has cut in due to:
– badly connected battery
– battery terminals crossed
– flat battery
– blown fuse
– wet circuit board
Turn the ignition key to the «STOP»
position and look for the cause of
the problem:
– check connections (see 3.4)
– check connections (see 3.4)
– recharge the battery (see 6.2.3)
– replace the fuse (10 A)
(see 6.3.5)
– dry using warm air
2. With the ignition key turned to
«START» the light flashes and
the starter motor does not run
– starting conditions have not
been met
– check that all starting conditions
are met (see 5.2.a)
3. With the ignition key turned
to «START» the light or the
dashboard come on, but the
starter motor does not run
– insufficiently charged battery
– malfunction on the starter relay
– recharge the battery (see 6.2.3)
– contact your Dealer
4. With the ignition key turned to
«START» the starter motor runs
but the engine does not start
– insufficiently charged battery
– faulty fuel supply
– faulty ignition
– recharge the battery (see 6.2.3)
– check the level in the tank
(see 5.3.3)
– open the fuel stopcock (if fitted)
(see 5.4.1)
– check the fuel filter
– check that spark plug cap is
securely fitted
– check that the electrodes are
clean and have the correct gap
between them
5. Starting is difficult or the engine
runs erratically
– faulty carburetion – clean or replace the air filter
– empty the fuel tank and refill with
fresh fuel
– check and replace the fuel filter if
necessary
6. Weak engine performance
during cutting
– forward speed too high in relation
to cutting height
– reduce the forward speed and/or
raise the cutting height
(see 5.4.5)
7. The engine shuts down whilst
working.
The safety device of the electronic
circuit board has cut in due to:
– the safety devices have cut in
Turn the ignition key to «STOP»
and look for the cause of the
problem:
– check that all starting conditions
are met (see 5.2.b)
8. The cutting means do not
engage or do not stop promptly
when they are disengaged
– problems with the engagement
mechanism
– contact your Dealer