1
2
3
4
5
6
1
2
3
4
5
Plate
Station
Screws for Holder
Holder (CT)
Paper template (CT)
Dowels
Hook
30 mm Screws
Place the paper template on the wall where you want
to place the charging station.
Make sure that the CEE power connection is within
a radius of 1.5 meters. Drill holes according to the
paper template.
Insert and countersink the dowels in the drill holes.
Remove the paper template.
1
2
Cable Type
Socket Type
95 mm Screws (ST)
Metal Bolts (ST)
Paper template (ST)
Display
The high-resolution colour display of the EM2GO charging unit shows you the following
information:
1.
Real-time charging power
2.
3-phase data (voltage and current)
3.
Charging time
4.
Power consumption
5.
Charging unit temperature
6.
Status display
LED strip display
The LED strip signals the status of the charger:
1.
No LED indication: Not in operation.
2.
LED permanently green: Charger is connected.
3.
LED green running: Charging in process
4.
LED permanently green: Charging process complete
5.
LED flashes red: There is a defect.
NOTE:
If the LED strip flashes red, the protection electronics of the EV charger was
addressed. In this case, please disconnect the mobile charger from the electric vehicle and
from the power grid. Submit the connections, cables and charger to a visual inspection.
If there are no visual defects, reconnect everything. If the red LED continues to flash, dis
-
connect the charger from the electric vehicle and the mains supply and contact your specialist
consultant.
Do not use the EV charger.
Charge vehicles
1.
First insert the CEE plug of the charger into a suitable socket.
2.
Remove the protective cap of the type 2 plug and connect it to the vehicle‘s charging
socket. Please note that the vehicle must be prepared and adjusted for charging.
The charging process begins.
If you have purchased the charging station as a socket type (ST), first connect your type 2
charging cable to the type 2 socket of the charging station, and then to the charging
connection of your electric vehicle.
3.
When charging is complete, remove the Type 2 plug from the vehicle‘s charging socket.
Put the protective cap back
NOTE:
On some models, charging does not start automatically.
In this case, press the switch on the charging unit.
Assembly instructions
Please take into account that the connection cable of the charging unit is only 150 cm (±5%),
your three-phase connection socket should be in this area. Once the wall charger has been
installed, switch off the fuse of the three-phase connection socket and connect the charging
unit to the CEE socket. You can now switch on the fuse.The charging unit is equipped with an
residual-current device (Type A RCD + 6ma DC filter). Please make sure that your three-pha
-
se socket is equipped with suitable residual-current devices.
Mounting accessories
GB
5
