9
© 2021, Elon Group AB. All rights reserved.
Connecting to floor drain
When delivered, the drain hose in the drying cabinet is connected to the removable water tank.
To connect the hose to a floor drain, do as follows:
Cabinet seen from rear
Route the drain
hose through one
of the cut-outs in
the panel
Hose to remova-
ble water tank
Hose from con-
densed water
pump
New hose to
floor drain
Elbow
Cut hose from
condensed
water pump
1 Carefully pull out the upper part
of the hose around 2–3 cm.
2 Cut through the hose at the middle of the
opening.
3 Attach the new drain hose and elbow that are
supplied in the installation kit, as illustrated.
The hoses are a push-fit on the elbow coupling.
4 Route the drain hose through one of the
cut-outs in the panel to prevent it from being
crushed.
5 Run the drain hose to the floor drain.
6 If the floor drain is higher than the outlet from
cabinet, make sure that the hose hangs
in an arc towards the floor and creates a
water trap. Otherwise there is a risk that the
condensed water could flow back towards the
compartment when the pump is not running.
This could cause the compartment to fill up
with water and damage the drying cabinet.
Connecting to water tank
If you want to reconnect the condensed water outlet to
the water tank you simply need to reconnect the two
hoses with the elbow coupling.
______________________________
NOTE!
The hose must never be bent so that it
obstructs the flow of water.
______________________________
