elvita CSJ4320S, User Manual

Page: 9 / 54

8 9
© 2022, Elon Group AB. All rights reserved.
Sort the laundry to be ironed according to the international symbols on the
garment label, or if this is missing, according to the type of fabric. Start ironing
the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool
down) and eliminates the risk of scorching the fabric.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without over-
flowing.
- Slowly pour the water into the reservoir using the special measure and
taking care not to go over the maximum level (about 250ml) indicated by
“MAX” on the reservoir [Fig. 2].
- Close the lid (2).
SELECTING THE TEMPERATURE.
- Put the iron in a vertical position.
- Put the plug in the socket.
- The LED screens corresponding stall light flashing indicates that the iron is
heating. Wait until the lights are on before you start to work. Default setting
temperature is at the min level on LED display.
SELECTING THE STEAM.
The quantity of steam is regulated by the steam selector (C).
- Move the steam selector to a position between minimum and maximum
depending on the quantity of steam required and the temperature selected
[Fig. 1].
Warning:
the iron gives off steam continuously only if you hold the iron hori-
zontally. You can stop the continuous steam by placing the iron in a vertical
position or by moving the steam selector to “0”. As indicated on the LED
display and in the initial table, you can only use steam at the highest temper-
atures. If the selected temperature is too low, water may drip onto the plate.