22
Installation - ENGLISH
© 2022, Elon Group AB. All rights reserved.
Install the rectangular pipes and the flexi pipe
1.
Place the rear edge of the hob on the counter, then tilt the front of the hob down.
2.
Install the rectangular pipes and the flexi pipe.
3.
Seal the joint parts with the sealant tape.
NOTE! For installations without carbon filter, see section "Installation options and requirements",
4.
Fill the remaining spaces between the benchtop and the hob with heat resistant silicone.
5.
Install the decorative lid, the metal grease filter and the water tank.
6.
Wipe the surface of the hob and counter with a damp cloth to prevent stains.
7.
Remove the protective foil on the hob.
Activate the carbon filter countdown
To use the carbon filter counter it has to be activated. When it is time to replace or clean the carbon filter
flashes.
Maximum countdown time is 150 hours.
1.
Touch
to turn on the hob.
2.
Touch and hold
and
for 5 seconds to activate the carbon filter countdown.
When the counter is activated and has started to count down, an acoustic signal sounds and
is lit for 20 seconds.
Electrical wiring
WARNING!
All electrical wiring must be installed by a qualified electrician.
