GB
46
9. Unscrew the top hinge pin, turn over the top hinge plate
and fit the pin as shown in the diagram. Put this part
aside for later. Skip step 9 if Rev.1 is written after the
model name on the rating label inside the appliance.
10. Swap the positions of the cables in the channels on the
left and right sides of door.
11. Move the door into the correct position, and adjust
1
(which is in the plastic bag if you have Rev.1) so that
the door is correctly positioned. Move the connecting
cable
2
in the door channel and then secure part
1
and the cable
2
with the screws
3
.
(Support the door to prevent it from dropping.)
ķ
ĸ
Ĺ
12. Reconnect the connectors
1
from step 3, then fit part
2
.
ķ
ĸ
13. Rotate part
1
through 180° and fit it to the other corner
of the door. Then fit part
2
. (Both were removed in step
2.)
1
2
14. Remove the magnetic switch from its holder (part
3
in
step 3) and fit it to the other holder marked “L/R”.
NOTE!
Make sure the magnetic switch sits in the correct holder to
suit the side it will be located on.
“L” = Left
“R” = Right
15. Fit part
1
, reconnect the connector
2
and refit part
3
.
1
Top hinge cover
