elvita CDM6601V, User Manual

Page: 72 / 152

GB
72
Space between
cabinet bottom and
floor
Electrical, drain and
water supply line
openings
90°
-
90°
820 mm
580 mm
80
100
600 mm (for 60 cm model)
450 mm (for 45 cm model)
Built-in installation (for the integrated
model)
Step 1. Selecting the best location for the dishwasher
The installation position for the dishwasher should be near
the existing inlet and drain hoses and power cord.
The illustrations below show the cabinet dimensions and the
recommended installation position for the dishwasher.
1. The gap between the top of the dishwasher and
cabinet, and between the edge of the outer door and
the edge of the cabinet can be less than 5 mm.
2. If the dishwasher is installed in a corner cabinet there
should be some space when the door is opened.
Dishwasher
Door of
dishwasher
Minimum
space of 50
mm
Cabinet
Step 2. Dishwasher installation steps
1. Fit the condensation strip under the work surface of the
cabinet. Please ensure the condensation strip is flush
with the edge of the work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher in position.
6. Level the dishwasher. The rear foot can be adjusted
from the front of the dishwasher by adjusting the screw
in the middle of the base of the dishwasher using a
cross-head screwdriver. To adjust the front feet, use a
flat-head screwdriver and turn the front feet until the
dishwasher is level.
7. Adjust the tension of the door springs by using an Allen
key turning in a clockwise motion to tighten the left
and right door springs. Failure to do this could cause
damage to your dishwasher.
8. The dishwasher must be secured in place. There are
two ways to do this:
A. Normal work surface: Secure the dishwasher to the
work surface with the wood screws and retaining
strip.
B. Marble or granite work top: Fix the sides with screws.
NOTE :
Depending on where your electrical outlet is, you may
need to cut a hole in the side of the nearest cabinet.