elvita CDM5600V, User Manual

Page: 72 / 152

GB
72
Integrated installation (for the
integrated model)
Step 1. Selecting the best location for the dishwasher
The installation position for the dishwasher should be near
the existing inlet and drain hoses and power cord.
The illustrations below show the cabinet dimensions and the
recommended installation position for the dishwasher.
1. The gap between the top of the dishwasher and
cabinet, and between the edge of the outer door and
the edge of the cabinet could be less than 5 mm.
2. If the dishwasher is installed in a corner cabinet there
should be some space when the door is opened.
Dishwasher
Door of
dishwasher
Minimum
space of 50
mm
Cabinet
NOTE :
Depending on where your electrical outlet is, you may
need to cut a hole in the side of the nearest cabinet.
Step 2. Adjusting the door spring tension
1. The door springs are set at the factory to the correct
tension for the outer door. If a wooden door panel is
fitted, you will have to adjust the door spring tension.
Rotate the adjusting screw to tighten or relax the steel
cable.
2. The door spring tension is correct when the door
remains horizontal in the fully opened position, but rises
to the closed position with slight finger pressure.
Step 3. Dishwasher installation steps
1. Fit the condensation strip under the work surface of the
cabinet. Please ensure the condensation strip is flush
with the edge of the work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher in position.
6. Level the dishwasher. The rear foot can be adjusted
from the front of the dishwasher by adjusting the screw
in the middle of the base of the dishwasher using a
cross-head screwdriver. To adjust the front feet, use a
flat-head screwdriver and turn the front feet until the
dishwasher is level.
7. Adjust the tension of the door springs by using an Allen
key; turn the key in a clockwise direction to tighten
the left and right door springs. Failure to do this could
cause damage to your dishwasher.
8. The dishwasher must be secured in place. There are
two ways to do this:
A.
Normal work surface: Secure the dishwasher to the
work surface with the wood screws and retaining
strip.
B. Marble or granite work top: Fix the sides with screws.
A
B
Step 4. Levelling the dishwasher
The dishwasher must be level to ensure correct dish racks
operation and wash performance.
9. Place a spirit level on the door and the rack guide inside
the dishwasher as shown to check that the appliance is
level.
10. Level the dishwasher by adjusting the three levelling
feet individually.
11. Once the dishwasher is level, make sure that it cannot
tip over.
Space between
cabinet bottom
and floor
Electrical, drain and
water supply line
openings
90°
-
90°
820 mm
580 mm
80
100
600 mm (for 60 cm model)
450 mm (for 45 cm model)