elvita CDM5600V, User Manual

Page: 85 / 152

GB
85
Adjusting the rinse aid reservoir
To achieve better drying performance with limited rinse aid,
the amount of rinse aid that is used for each wash can be
adjusted by the user. Follow the steps below.
1.
Close the door and switch on the appliance.
2.
Within 60 seconds after step 1, press the Program
button for more than 5 seconds, then press the Delay
“+” button to enter setup mode; the rinse aid indicator
will flash once per second.
3.
Press the Program button to choose the correct setting
to suit your water hardness; the settings will change
in the following sequence: D1->D2->D3->D4->D5-
>D1. The higher the number, the more rinse aid the
dishwasher uses.
4.
To exit setup mode, press the Power button or leave the
setting unchanged for 5 seconds.
Filling the detergent dispenser
The dispenser can be opened in
one of the two following ways:
1.Open the cap by sliding the
release catch.
2. Open the cap by pressing down
the release catch.
Add detergent to the larger cavity
(A) for the main wash cycle. For
better cleaning result, especially if
you have very dirty items, pour a
small amount of detergent onto the
door (B). The additional detergent
will activate during the pre-wash
phase.
Close the flap by sliding it to the
front and then pressing it down.
1
Press down
1
2
2
A A
B B
NOTE :
• It may be necessary to adjust the setting depending
on how dirty the dishes are.
• Please follow the manufacturer’s recommendations
on the detergent packaging.
3
Slide to the right