66
67
© 2021, Elon Group AB. All rights reserved.
About the safety supply hose
The safety supply hose is double-walled. The design of the hose
ensures that it will stop the flow of water if the hose is damaged
and the air space between the inner and the outer corrugated
hose fills up with water.
WARNING
If your sink has a spray jet fed by a hose that is connected to the same
water line as the dishwasher the hose could burst. If your sink has one, it is
recommended that the hose be disconnected and the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hose completely out from the storage
compartment at the rear of the dishwasher.
2. Screw the end of the safety supply hose to the tap using
the 3/4 inch threaded coupling.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the tap.
Connecting the drain hose
Insert the drain hose into a drain pipe with a minimum diameter
of 4 cm, or let it run into the sink, making sure to avoid bending
or squashing it. The height of the drain pipe must be less than
1000 mm. The free end of the hose must not be immersed in
water to prevent water from flowing back into it.
Securely fix the drain hose in either position A or position B
How to drain excess water from hoses
If the sink is higher than 1000 mm from the floor, the excess
water in the hoses cannot drain directly into the sink. It will be
necessary to drain excess water from hoses into a bowl or
suitable container that is held lower than the sink.
Water outlet
Connect the water drain hose. The drain hose must be correctly
fitted to avoid water leaks. Ensure that the water drain hose is
not kinked or squashed.
Extension hose
If you need a drain hose extension, make sure to use a similar
drain hose.
It must be no longer than 4 metres; otherwise the cleaning
performance of the dishwasher could be impaired.
Syphon connection
The waste connection must be made at a height of less than
1000 mm from the base of the dishwasher. The water drain
hose should be fixed.
Positioning the appliance
Place the appliance in the desired location. The back should
rest against the wall behind it, and the sides should be close to
the adjacent cabinets or walls. The dishwasher is equipped with
water supply and drain hoses that can be positioned either on
the right or the left sides to facilitate proper installation.
Levelling the appliance
Once the appliance is positioned for levelling, the height of the
dishwasher may be altered by screwing the feet in or out. The
appliance must not be tilted more than 2°.
Rear of dishwasher
Power cord
Drain hose
Water inlet
Drain hose
A
B
Work
surface
MAX 1000mm
40 mm
NOTE
!
Only applies to free-standing dishwasher. Check that all transit
bolts have been removed and that the spray arms can move free-
ly. Complete installation by running a program of your choice.
