17
OPERATING MODE Button
Press the MODE button to select the operating mode and choose the fan speed and the
dehumidification level. The fan speed indicator LOW FAN will flash green and the indicator for
dehumidification will flash while setting the humidity level. During the setting process the appliance
will run in low fan speed only and the fan speed can not be adjusted.
NEGATIVE ION MODE
The process of inonisation of the ambient air is started by pressing the IONISATION button and stops
when the button is pressed again. When the button is pushed the ION indicator light will flash and
the indicator light goes off when the button is pushed again to stop the ionisation process.
TIMER MODE
When the appliance is running, press the TIMER button to set a switch-off time. Press the
SETTINGS button to set a running time until automatic switch-off in hourly steps from 24h –
23h –22h … – 1h. The time indication flickers for five seconds while setting the timer and
stops when no further settings are entered. Then the display will show the ambient humidity
in the room.
When the appliance runs in TIMER mode and you want to check the remaining running time
press the TIMER button and the display will show the remaining time before automatic
switch-off. The time will be indicated by flashing for five seconds, then the display will revert
to ambient humidity.
While the remaining time is flashing on the display you can press the TIMER button to cancel
or deactivate automatic switch-off mode.
When the appliance is powered off, you can press the TIMER button to set a wake-up time
for the appliance to be automatically switched-on. The procedure is the same as for setting a
switch-off time. The „Time-to-start“ is shown on the display flashing for five seconds and if
no further input occurs, the display will resume showing the ambient humidity in the room.
While the remaining time is flashing on the display you can press the TIMER button to cancel
or deactivate automatic switch-on mode.
