Elumen8 ELUM021, User Manual

Page: 15 / 36

C 14C
BL.O. Gobo Change — Blackout while change gobo
To select the BL.O. Gobo Change , press the ENTER button to confirm. Use the UP / DOWN buttons
to select No (normal while changing gobo) or Yes (blackout while changing gobo), press the
ENTER button to store. Press the MENU button back to the last menu or leave the unit idle for
one minute to exit menu mode.
Lamp Setting
To select the Fixture Setting , press the ENTER button to confirm, use the UP / DOWN buttons to
select On/Off, State/Power on, Off via DMX, On if DMX on, Off if DMX off, Ignition Delay or Low
Power Delay. .
On/Off — Turn on/off the lamp
To select the On/Off , press the ENTER button to confirm. Use the UP / DOWN buttons to select On
(lamp on) or Off (lamp off), press the ENTER button to store. Press the MENU button back to the
last menu or leave the unit idle for one minute to exit menu mode.
State/Power On — Lamp state while power on
To select the State/Power On , press the ENTER button to confirm. Use the UP / DOWN buttons to
select On (Lamp on while power on) or Off (Lamp off while power on), press the ENTER button to
store. Press the MENU button back to the last menu or leave the unit idle for one minute to exit
menu mode.
Off via DMX — Turn off the unit via DMX controller
To select the Off Via DMX , press the ENTER button to confirm, the present mode will blink on the
display, use the UP / DOWN buttons to select Yes (turn off the unit via DMX controller) or No
(Don’t turn off the unit via DMX controller), press the ENTER button to store. Press the MENU
button back to the last menu or leave the unit idle for one minute to exit menu mode. (When you
operate the unit via a DMX controller, set the value of the “special function” channel to “lamp off”.
wait for 5 seconds, then the lamp will turn off if you have chosen “yes” mode).
On if DMX is Detected — Lamp turns on when DMX signal is detected
Select On for the lamp to come on when DMX is detected, press the ENTER button to confirm, the
present mode will blink on the display, use the UP / DOWN buttons to select Yes (Lamp turns on
when DMX signal is detected) or No (keep the present state), press the ENTER button to store.
Press the MENU button back to the last menu or leave the unit idle for one minute to exit menu