Setup
The following sections will guide you through
the setup of the printer and installation of
Create-A-Label Tools software.
Step
➊
Install the Battery
Locate the battery access door on the rear of
the printer. Press down on the door latch to
open the compartment. The battery and com-
partment are shaped so that the battery can
only be inserted in one orientation. Push the
battery in and down until it locks in position. If
the battery is charged, the green Power/Fault
indicator will light for 10 seconds then go off.
Close and latch the door to secure the battery.
Figure 1-1
Install Battery
Getting Started
4
980088-001 Rev. A
AutoSense
Gap Sensor
Adjustment
To activate the AutoSense feature, first remove
the printer battery. Load labels into the printer
(do not use the dispenser), then press and hold
the FEED Control while re-installing the bat-
tery. Release the FEED Control when the indi-
cator starts flashing RED. The printer will
advance 3-4 labels while performing the ad-
justment. When the adjustment is complete, a
status summary label will be printed and the
printer will be placed in Diagnostic Dump
mode. Tap the FEED Control once to switch
the printer back to normal operation. When the
POWER/FAULT indicator switches to GREEN,
the printer is ready for use. If the indicator
continues to glow ORANGE or switches to
RED, refer to Appendix A for troubleshooting
information.
Operation
980088-001 Rev. A
17
