WOP-12ac. Quick guide
16
•
•
•
•
In the
Single IP Management
menu, perform the following configuration:
Cluster Management Address
– specify unique IPv4 address via which the device may access the master
cluster. The master should be located in the same subnet with the cluster and not match IP address of
other devices.
192.168.100.250
is used in the example.
To apply a new configuration and save setting to non-volatile memory of the access point, click
Update
.
To enable cluster mode, select
On
in the
Clustering
field.
To enable automatic channel selection according to the data on channels used by neighbouring access points
and spectral analysis of environment on third-party access points noise, switch to the
Radio Resource
Management
tab and click
Start
in the
Channel Planner
section.
To enable automatic output power distribution of the access point according to influence of neighbouring
access points which operate in the same cluster, switch to the
Radio Resource Management
tab and click
Start
in the
Transmit Power Control
section.
In the
Locked
field, channel change for the radio interface of the access point can be locked. If the flag is set,
when the optimal channel is selected by all access points, this radio interface will use the previous channel for
any outcome of the optimal channel selection.
In the
Advanced
menu, perform the following configuration:
Change channels if interference is reduced by at least
– select a percentage that the interference must be
reduced by for the access point to change channels.
“
75%
”
is used in the example;
Refresh when access point is added to the cluster
– enable re-counting of common spectral structure of
environment and selection of optimal channel for the access point (
enable
value) when new access
point is being connected to the cluster.
Determine if there is better set of channel settings every
– set a time interval to schedule updates of
environment spectral structure determination and selection of better channel for the access points.
“
1Day
”
is used in the example.
To apply a new configuration and save setting to non-volatile memory of the access point, click
Update
.