2
Elterm M.M.Kaszuba Sp.J., ul. Przemysłowa 5, 86-200 Chełmno
www.elterm.pl
Safety instructions:
1.
The installation of this
Admiral
appliance set must be in compliance with the National Electrical Code, as
well as your local electrical and plumbing codes.
2.
The unit must be properly earthed in accordance with all current regulations and laws.
3.
Flow heater has to be connected and used in accordance with this manual.
4.
All wiring and installation must be supervised by a qualified and trained electrician.
5.
This appliance is not intended for use by persons (including children) with reduced physical sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
6.
This appliance must be permanently connected to the fixed circuit breaker and it must be installed
vertically. Do not install this appliance near to tinder or strong magnetic field place.
7
. Keep the flow heater off when exposed to freezing, do not install this unit in below zero °C conditions.
8
. Please test the outlet hot water temperature with your hand to make sure it is suitable for showering
before doing so.
9
. The heating chamber is treated with composite nano insulation material; it is natural if there might be a
bit of smell or green blue smoke when the unit is used for the first time.
10
. In case of cable/wire damage you must contact qualified electrician to replace it with a new wire(s).
11
. Please flush the system through completely by opening the hot tap on the water heater circuit furthest
away from the heater. Allow all air and debris to pass before closing the hot tap.
12
. Before the installation please make sure that water flow is present, only then connect the power supply.
The heater cannot be activated without water supply, otherwise damage may occur.
13
. Opening external casing of this flow heater may result in electric shock.
14
. Lack of mesh filter on supply side may cause damage and may void the warranty.
15
. This water heater may cause small amount of water expansion due to residual heat after operation. In
most systems this is easily accommodated by the distribution pipework and water supply system
Please read this manual prior installation and use of purchased product. Efficiency of every flow heater is
mentioned in technical data table. Using unit with insufficient power compared to hot water requirement
will result in too low output temperature.
Do not turn flow heater on in case of suspicion, that it may contain frozen water!
Instantaneous flow heater
Admiral
requires permanent connection to electrical network,
installation itself should be done by qualified electrician (in accordance with manual).
Flow heater cannot be connected to electrical installation using electric plug.
