11
Elterm M.M.Kaszuba Sp.J., ul. Przemysłowa 5, 86-200 Chełmno
www.elterm.pl
P01 – Boiler power – manual distribution
Shows current boiler power setting (99% stands for 100%),
increase power (67%, 100%),
decrease power (67%, 33%), confirm setting (100% is recommended),
go to P2 function.
P02 – Pump operation time setting
Shows current pump operating time,
increase operating time (3, 5, 10, ON),
decrease
operating time (1, 3, 5, 10),
confirm setting (10 is recommended), parameter on display sets
continuous pump operation independently of boiler heaters operation status,
go to P03
function.
P03 – PID controller
Shows current PID setting,
increase coefficient (2-5)
decrease coefficient (1-4),
confirm setting (3 is recommended).
Note: if it takes too long for boiler to reach required
temperature, set coefficient on 4 or 5 and to 1 or 2 if the increase is too fast.
Do not remove boiler external metal casing once device remains turned on. In case boiler is activated
by mistake with no water inside, wait until heaters cool down, fill device with water and switch it on
again. Under no circumstances fill device with cold water with heaters still hot! Once water in central
heating system is heated, system should be bled once again (special attention must be paid to the
bleeding of the central heating pump and boiler air vent).
NOTES
.....................................................................................................................................................................
.....................................................................................................................................................................
.....................................................................................................................................................................
.....................................................................................................................................................................
Elterm boilers are equipped in
AntiStop function
. Automatics turns the pump on for one minute once every
14 days, what prevents it's rotor from seizing. AntiStop operates independently from on/off mode. It is
therefore highly recommended to keep boiler in off mode (red diode visible) in off-heating season - in this
mode device uses just 0,5W!
