44
The basic display shows the “Energy” window in the main loop when the meter is attached to the pipe,
the pipe is completely filled with water and there is no error (sequence 1.1). If there is an error it is
shown permanently in the basic display. The meter doesn’t switch to the power save mode. Is the
cause of error removed the error disappears from the display. See Section 8.3 Display indications
(default settings).
The loop settings can be programmed to suit customer-specific requirements using the IZAR@SET
software.
The pushbutton is used to switch through the various displays. The button can be pressed for a short
or long time.
The following table shows the possible uses of the button:
Action
Result
Short press =>
▼
(< 3 seconds)
Switches to the next display within a loop
Long press
(> 3 seconds)
Switches to the next display loop
Button not pressed for 4 minutes
Meter switches off the display automatically (to save power,
but only if no error exists)
Button pressed again
Meter shows the basic display