MUL
TIPOINT
15
NOTE:
The first operation of the handwash is intended to ensure the heater
unit contains water before the appliance is switched on.
7.1 Before turning on the electricity and mains water to the handwash, ensure the
control knob is turned fully clockwise.
7.2 Turn on the main water supply at the isolating stop valve and slowly turn the
control knob clockwise, (it will take appoximately 30 seconds for a smoth
flow of water to be obtained whilst any air is being dispersed from the
handwash).
7.3 Stop the water flow by rotating the control knob clockwise.
7.4 Turn on the electrical supply at the isolating switch.
7.5 Rotate the control knob half a turn anti-clockwise. After approximately
15 seconds, the water will start to heat.
7.6 To obtain warmer water turn the control knob clockwise and for cooler water
turn anti-clockwise.
7.7 Shut off the handwash by turning the control knob clockwise. The appliance is
now ready to use.
7.8 The neon will illuminate when the water is heating.
7.0 COMMISSIONING
15
