MUL
TIPOINT
11
PIPE ENTRY
4.9 Plumbing entry can be from the rear (preferred) or from the bottom. The
backplate has a cut out position to suit 15mm pipe.When opting for
bottom entry make cut out before fitting backplate to the wall - see
Figure 6 (below).
5.1
TURN OFF
water and electrical supply.
5.2 The appliance is designed for bottom and rear entries of water and electric
cable.
It is advisable to use the rear entry (when it is possible), in order
to obtain a neater installation.
5.3 Unscrew the retaining screws and lift the cover from the back plate -
see Figure 7 (below).
5.0 FITTING INSTRUCTIONS
5.4 Fit the outlet spout -
DO NOT
over tighten, finger tight will be sufficient
- see Figure 8 (above).
5.5 After choosing the correct site for the handwash, use the backplate as a
template and mark the two fixing holes (see p.9).
BEWARE OF CABLES AND PIPES WHICH MAY BE BURIED IN THE
WALL.
5.6 Drill holes using a 6.5mm diameter masonry drill.
5.7 Use plugs to suit the wall and use the fixing screws supplied.
Figure 7 Removing Cover
Make cut-out
using sharp knife
Figure 6 Plumbing cut-out
Figure 8 Fitting outlet spout
'O' rings
Plastic nut
(finger tight only)
Outlet pipe
11
