53
Parameter setting
Sensor Sewi KNX TH-L-Pr
• Version: 17.11.2016 • Technical changes and errors excepted.
Set, in which cases the correction factor
received via object is to be retained. Please
note that the setting "After power supply restoration and programming" should not be
used for the initial start-up, as the factory settings are always used until the first com-
munication (setting via objects is ignored).
Specify the starting correction factor.
Examples:
For a factor of 1.234 the parameter value is 1234.
For a factor of 0.789 the parameter value is 789.
For a factor of 1.2 and a reading of 1000 Lux the transmitted value is 1200 Lux.
6.10. Brightness threshold values
Activate the required brightness threshold value. The menus for setting the threshold
values are displayed.
6.10.1. Threshold value 1/2/3/4
Threshold value
Set, in which cases threshold values and delay times received are to be kept per object.
The parameter is only taken into consideration if the specification/ setting by object is
activated further down. Please note that the setting "After power restoration and pro-
gramming" should not be used for the initial start-up, as the factory settings are always
used until the first call (setting via objects is ignored).
Select whether the threshold value is to be specified per parameter or via a communi-
cation object.
Maintain the
correction factor received via
communication object
• never
• after power supply restoration
• after power supply restoration and
programming
Start correction factor in 0.001
valid till first communication
1 ... 10000; 1000
Threshold value 1/2/3/4
No • Yes
Maintain the
threshold values and delays received via
communication objects
• never
• after power supply restoration
• after power supply restoration and
programming
Threshold value setpoint using
Parameter • Communications object