19
Setting the parameters
Cala KNX M-T push button
• Version: 13.09.2019 • Technical changes and errors excepted.
All LEDs individually controllable
This is where you set the brightness of the LEDs, whether objects are used and whether
the LEDs switch off automatically after pushing the button.
5.6. Logic
The device has 8 logic inputs, 2 AND and 2 OR logic gates.
Activate the logic inputs and assign object values up to 1st communication.
Activate the required logic outputs
AND logic
OR logic
Use objects
No • Yes
Object value on/off after reset
(
if objects are used
)
0 • 1
Use automatic switch-off after pressing a
button
No • Yes
Switch off after
(is automatic switch off is
used)
1 ... 255; 30 secs. after pressing
LED mode
All LEDs individually controllable
Brightness
0 ... 100%; 30%
Use objects
No • Yes
Object value on/off after reset
(
if objects are used
)
0 • 1
Function LED 1 (top left) / 2 (top right) / 3
(bottom left) / 4 (bottom right)
• always OFF
• On after pressing button for settable time
• On for object value = 1 /
Off for object value = 0
Lighting period after pressing (
if "On after
pressing button for a settable time"
)
1 ... 5 seconds ; 3 seconds
Object value after reset (
if "On for object
value = 1 / Off for object value = 0
)
0 • 1
Use block object (
if "On for object value = 1
/ Off for object value = 0
)
No • Yes
Use logic inputs
Yes • No
Object value prior to 1st communication for
- Logic input 1 ... 8
0 • 1
AND logic 1/2
not active • active
OR logic 1/2
not active • active
