elsner elektronik 71280, Installation And Adjustment

Page: 26 / 48

24 Setting the parameters
Nunio KNX M-T push button • Version: 25.02.2021 • Technical changes and errors excepted.
The status object reports the current status of the control variables (0% = OFF,
>0% = ON) and may for example be used for visualisation, or to switch off the
heating pump as soon as the heating is switched off.
Then define the type of control . Heating and/or cooling may be controlled in two lev-
els.
General setpoint values
Determine if the modified set point values should be kept after a mode change, or if
they should reset to the standard specified here.
You may enter separate setpoint values for each mode or use the comfort setpoint as
a basic value.
If you are using the control for both heating
and cooling, you may also select the set-
ting "separately with switching object". Systems used for cooling in summer and for
heating in winter can thus be switched from one to the other.
If you are using the basic value, only the deviation from the comfort setpoint value is
listed for the other modes (e.g, 2°C less for standby mode).
Send status objects • on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
Cycle
(if sent periodically)
5 s • ... • 5 min • … • 2 h
Type of control • Single level heating
• Dual-level heating
• Single-level cooling
• Single-level h single-level cooling
• Dual-level h single-level cooling
• Dual-level h dual-level cooling
Keep modified set points after mode
change No • Yes
Setting the setpoint values • with separate setpoint values with
Switching object
• with separate setpoint values without
Switching object
• with comfort setpoint as a basis with
Switching object
• with comfort setpoint as a basis without
Switching object
Behaviour of the switching object at value
(with switching object)
• 0 = Heating | 1 = Cooling
• 1 = Heating | 0 = Cooling
Value of the switching object after reset
(with switching object)
0 • 1