21
Setting the parameters
Nunio KNX M-T push button
• Version: 25.02.2021 • Technical changes and errors excepted.
9.
Setting the parameters
9.1.
Behaviour on power failure/ restoration of
power
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block.
9.2.
General settings
Set basic characteristics for the data transfer.
9.3.
Temperature Measurement
Select, whether a
malfunction object
is to be sent if the sensor is faulty.
Use
Offsets
to adjust the readings to be sent.
The unit can calculate a
mixed value
from its own reading and an external value. Set
the mixed value calculation if desired. If an external portion is used, all of the following
settings (threshold values, etc.) are related to the overall reading.
Transmission delay after reset/restoration
of bus
5...300 s
Maximum telegram rate
1 • 2 • 5 • 10 • 20 • 50
Telegrams per second
Use malfunction object
No • Yes
Offset in 0.1°C
-50…50; 0
Use external measured value
No • Yes
Ext. Reading proportion of the total reading
5% • 10% • ... • 50% • ... • 100%
Sending pattern for internal and total
measured value
• never
• periodically
• on change
• on change and periodically
At and above change of
(if sent on change)
0.1°C • 0.2°C • 0.5°C • ... • 5.0°C
Send cycle
(if sent periodically)
5 s • 10 s • ... • 2 h
Summary of Contents for 71280
Page 1: ...Nunio KNX M T Push Button Item number 71280 EN Installation and Adjustment ...
Page 2: ......
Page 47: ......
