2
Quick start instructions
Place operator in correct position (Pinion wheel to be
parallel to the gate and stepped out to allow for width
of rack once it is mounted onto the gate frame). Mark
out fixings and fix operator to the concrete pad.
Fix rack to the gate frame keeping 1mm-2mm clearance
between the rack teeth and Pinion wheel
Once the rack is fixed move the gate and sight the
rack moving over the pinion wheel, check that most of
the pinion wheel meshes with the rack. Make sure
rack runs freely over the pinion wheel, any tights
spots should be corrected by adjusting the rack height.
Check the operator is firmly bolted down to the
concrete pad.
Ensure stops are installed on the gate for the fully closed and
fully open positions.
Connect required P.E Beams.
Limit switches can be used in 2 different configurations
1. Limit switch initiates ramp down and the gate stops as per ramp down time.
2. Limit switch initiates slow speed and the gate stops on slow speed overload after hitting the end
stoppers.
Follow the on screen instructions to commission the gate.
