elrest eVISIO PTE715, Device Description

Page: 14 / 43

Device description elrest Automationssysteme GmbH
e VISIO PTE715_Windows.EN Page: 14
2 Implementing
2.1 Mechanical installation
Safety notes at the workplace:
Before installating and starting up, the manual must be read and followed carefully. The relevant EN and
VDE regulations are valid.
WARNING Before starting up, adapt the device to the room temperature. By condensation you can switch
on the device only after it is completely dry.
To prevent the device from overheating:
- avoid direct sun contact to the device,
- do not cover the vents,
- ensure sufficient air circulation
2.1.1 Space requirement
There must be considered sufficient access to the equipment, for the operator and for maintenance work
during the installation.
Ensure sufficient air circulation during installation.
2.1.2 Installation / Assembly
The valid local, and in particular, electrical safety regulations must be kept.
Safety notes at the workplace:
•
The devices are intended for installation in switching cabinets
•
The protection rating IP20 has to be warranted;
•
The installation point has to be in a solid position with low vibration.
2.1.3 Assembly/Disassebly
As standard, the mounting position is vertical. (See chapter Mounting position )
According to the installation positions, the valid maximum ambient temperature has to be respected.
WARNING •
Ensure that there is sufficient clearance between the neighboring devices that the
natural convection can ensure sufficient cooling.
•
Bring the system into a safe, de-energized state before starting installation,
disassembly or wiring of the device!