Elo TouchSystems E391994, User Manual

Page: 76 / 81

UM600xxx Rev 01, page 76 of 81
User Manual
–
Elo I-Series 4
Notice to Users in Canada for IC compliance: This equipment complies with the Class B limits for radio noise emissions
from digital apparatus as established by the Radio Interference Regulations of Industrial Canada.
CAN ICES3 (B)/NMB3(B)*
*IO HUB = CAN ICES3 (A)/NMB3(A)*
*Z30 w CFD = CAN ICES3 (A)/NMB3(A)
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with
the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification
for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which means
that the equipment has been tested to the following Directives and Standards: This equipment has been tested to the
requirements for the CE Mark as required by EMC Directive 2014/30/ EU as indicated in European Standard EN 55032
Class B and the Low Voltage Directive 2014/35/EU as indicated in European Standard EN 62368-1.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to this
manual the equipment may cause interference with radio and television communications. There is, however, no
guarantee that interference will not occur in any particular installation due to site-specific factors.
1.
In order to meet emission and immunity requirements, the user must observe the following:
a.
Use only the provided I/O cables to connect this digital device with any computer.
b.
To ensure compliance, use only the provided manufacturer’s approved line cord.
c.
The user is cautioned that changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
2.
If this equipment appears to cause interference with radio or television reception, or any other device:
a.
Verify as an emission source by turning the equipment off and on. If you determine that this equipment is causing
the interference, try to correct the interference by using one or more of the following measures:
i.
Move the digital device away from the affected receiver.