Elo TouchSystems AccuTouch 821615-000, Product Manual

Page: 48 / 107

4-53
External Controllers
Installing the 2210MX Serial Controller
Using the 2210MX external serial controller may simplify the overall
integration process.
Begin by deciding where to mount the controller on the rear of the display case.
The dimensions of the enclosure are 4.14 in x 2.34 in x 0.9 in. Provide room for
easy access and installation of all cables.
Complete the following steps to install the controller:
1 After choosing a location, drill a 0.625-inch diameter hole for cabling exiting
the display and drill two holes for screws that will be mounted in the display
case.
2 After you drill the holes, route the transient suppression cable
(P/N 484815-000) out through the 0.625-inch diameter hole in the display
case.
Note: Transient suppression cables should always be used unless you are using an LCD
display.
3
Attach the 1x5F connector on the transient suppression cable to the 1x5M
header at P3 on the controller.
4
Mount the 2210MX to the display case.
5
Connect the 1x5F connector on the touchscreen cable to the
1x5M connector on the transient suppression cable.
6
Connect the ground wire of the transient suppression cable to an appropriate
ground inside the display.
7
Pull any excess cabling back into the display case.
8
Reattach the case to the monitor.
Complete the following steps if you are using a wall mount power supply:
1
Two different wall mount power supplies are available. Use P/N 580979-000
if you are using this inside the United States and P/N 319865-000 if you are
using this outside of the United States.
2
Plug the single male connector on one end of the power supply into the
connector on the serial cable.
3
Plug the other end of the power supply into a proper receptacle.
4
Plug the DB9F end of the attached serial cable into a serial port.
5
Proceed to “Where to Go from Here” on page 3-30.