Elo TouchSystems AccuTouch 821615-000, Product Manual

Page: 22 / 107

3-27
PC-Bus Controller
Contents
This configuration includes the 2201 PC-Bus controller and a touchscreen
cable.
Installation
Complete these steps:
1 Configure the controller.
2 Install the controller in your PC and connect the touchmonitor.
Configure the Controller
The controller is shipped preconfigured for use with Elo software. Except for
the Base I/O Port and Interrupt (IRQ) settings, no changes are necessary for
most users. Specific jumper settings and options available for your controller
are listed in Appendix B.
If your software does not support the 2201 directly, you may operate the
controller in E271-141 emulation mode. See B for jumper settings.
Additional technical information about the 2201 controller can be found in the
SmartSet Touchscreen Controller Family Technical Reference Manual,
available at
www.elotouch.com/support/dwnldmnls.asp .
Install the Controller in Your PC and Connect the Touchmonitor
Complete these steps:
1 Discharge any static charge on your body by touching the back of the
computer cabinet.
2 Note the Base I/O Port for use with the driver software. Factory default
settings are 280 (hexadecimal) and no interrupt. (The driver software selects
the interrupt.)
3 Turn the computer off and unplug the AC power cord from the outlet.
4 Remove the computer's cover. Refer to the computer user's manual for
instructions.
5 Choose an available expansion slot.
6 Remove the screw holding the expansion slot's access bracket, then remove
the bracket.